Qondio
Front
Intel
IntelMart
Shares
My Qondio
Account
janetra > Intel > Stihl and Husqvarna Chain Saws > Chain Saw Safety Tips

qondio.com/ykim PRINT EMAIL

Chain Saw Safety Tips

Be Prepared

Before you use a chain saw always read the operators manual and, if possible, find someone experienced in operating a chain saw to give you some training. Familiarize yourself with the recommended procedures for operating the saw safely before you start. Do not rely on learning as you go along as operating a chain saw without knowing the safe way to do it will lead to accidents and injury.

Chain saws are dangerous machines so make sure you are in good physical and mental condition. Never operate a chain saw when under the influence of alcohol or medications that can affect you mentally. If you are not well rested and alert you are much more likely to have an accident.

Clothing

Wear adequate protective clothing including safety goggles, hearing protectors, a hard hat, gloves, steel toed shoes and close fitting clothes. To protect the left side of the leg where injuries occur most often from chain saws you could wear specially manufactured chaps.

Choose the Most Suitable Chain Saw

For light work a saw with a bar between eight and twelve inches would be adequate. These would cope with cutting small branches and felling trees with diameter between six and ten inches. For log cutting and felling trees with twelve to eighteen inch diameter use a medium chain saw with a fourteen to twenty inch bar.For professional use a heavy weight saw with a bar above twenty inches would be the one to choose.

Maintain The Saw

Sharpen the teeth with a file or grind while wearing gloves or covering the chain with a heavy cloth. Check your manual for specific instructions for sharpening. Chain sharpeners are also available. Gasoline engines must be checked regularly to ensure the air filter is clean, the spark plugs are good and the muffler working adequately. Check the chain tension and oil the chain saw regularly. Always use the recommended bar oil. The chain tension is very important as a loose chain could come of the bar and cause injury. A too tight chain will bind in the wood and wear out sooner. Chains stretch during use so need readjusting often.

Operating the Chainsaw

With one hand holding the saw by the top handle use the other to pull the starting rope. Always start the chainsaw on the ground in a stable position not in the air. Control the saw using both hands, using only one hand to hold the saw is dangerous. Do not force the saw through the wood. A properly sharpened saw will cut without any extra pressure, however keep in mind the hardness of the wood as this will effect the speed which the saw will cut through.

Preventing Kickback

A major cause of injury when operating a chainsaw is kickback. This occurs when the teeth catch as they rotate. This causes the blade to kick back towards the operator violently. This can happen when the front of the blade hits an object, the cut is started improperly or the front of the blade catches the saw cut on reinsertion. Using a tip guard is the best way to avoid kickback. It can however cause limitations. Maintaining a firm hold on the saw and using a kickback guard or chain-brake can limit the occurrence of kickback.

Be careful to avoid any situation where the blade can be pinched. When reinserting or removing the blade use a high speed and cut branches with the base of the blade not the tip. Dull teeth can lead to kickback so keep the teeth sharpened. Never operate the saw above shoulder height as it will be difficult to control.

Use your chain saw safely and avoid ending up in the emergency room!

Contributed by janetra on August 18, 2008, at 12:41 PM UTC.

PLEASE VISIT THE CONTRIBUTOR'S WEBSITE
Stihl and Husqvarna Chain Saws
Selling Stihl and Husqvarna chain saws
www.best-power-saws.com

Reactions

No reactions yet.

Rate This Intel

Please login or sign up to rate this intel.

Comments

Please login or sign up to add a comment.

Good tips. Chainsaw wounds are ghastly... maybe these tips can help someone.

Roy Dixon Aug 18, 2008 12:52
I was working the landing bumping knots when my chainsaw slipped. It fell right toward my leg, tore into my chaps. The leg was fine not a scratch, the chaps were destroyed. They took my off the landing and put me back on the skidder. Great article and very important.

Aylewand Aug 18, 2008 16:49

Share

Copyright Notice

The copyright for this content entitled "Chain Saw Safety Tips " has been specified by the contributor as:

All Rights Reserved

This content may not be copied, distributed or adapted by anyone under any circumstances.

Login Here with
Any Email Address
Any Password
No account? Sign up.

Intel Contributor
This intel was contributed by janetra


Qondio Archive
May, 2012
123456
78910111213
14151617181920
21222324252627
28293031


2008
January, February, March, April, May, June, July, August, September, October, November, December
2009
January, February, March, April, May, June, July, August, September, October, November, December
2010
January, February, March, April, May, June, July, August, September, October, November, December
2011
January, February, March, April, May, June, July, August, September, October, November, December
2012
January, February, March, April, May

Sign Up
Not a member yet? Qondio is a powerful network for making it online. If you have a website to promote, we can help. Sign up and get in on the action.

About Qondio
Welcome to Qondio! Discover the awesome power this network can deliver by going to our About page. Or you could skip straight to the Sign Up form.

ABOUT
SUCCESS GUIDE
FEATURES
FAQ
ADVERTISE
CONTACT
USAGE POLICY
PRIVACY POLICY


TWITTER
FACEBOOK